GC Fujivest Super is a high quality investment material; ideal for impllant superstructures and long span bridges. It combines the benefits of traditional phosphate bonded investments with the time saving advantage of quick heating.

Indications:
-	For quick and step heating
-	With special attention for precious and semiprecious alloys
-	Perfect fit even for long span resolutions
Time Saving:
-	Can be fired at the final temperature just 20 minutes after mixing.
-	Perfectly suited for quick heating investments
	Of particular importance to the dental technician is the suitability of GC Fujivest Super® for laboratory application - a suitability amply demonstrated by its physical properties. The amount of time saved speaks for itself. After a mere 20 minutes, the product is set and can be placed in the pre-heated furnace at the final temperature.
Superb Accuracy:
-	Impressive casting results.
-	Extremely smooth surfaces.
-	Reproduces even the tiniest details.
-	Control expansion by dilluting the liquid.
	GC Fujivest Super Product B Photo 125x magnification of the investment surface. GC Fujivest Super Product B Finished gold casting (magn. 25x) with surface structure High Precision Investments The use of carefully balanced, fineparticle filler in the powder mix significantly reduces surface roughness, and improves the surface quality of the final cast.

Features and Benefits:

Ease-of-Use:
-	An extremely fluid consistency allows even the finest modelling edges to be reproduced, down to the smallest detail. The working time of up to 4 minutes is conducive to careful, controlled investment. The critical aspect of edge stability is guaranteed by good compressive strength (5 MPa).
-	The final cast - a very smooth surface structure down to the finest detail.
-	GC Fujivest Super® is a widely applicable, high quality investment material, which fully satisfies the requirements of the modern dental laboratory.
-	It combines ideally the benefits of traditional materials with the time-saving advantage of quick-heating.
	Extremely fluid consistency Smooth cast without sprues
Controllable Expansion:
-	Exact control of the total expansion is crucial for the accuracy of the fit of the castings. Here again, the procedure is straight-forward and geared to routine, practical use.
	Expansion: 100% Liquid: 100% Water: Setting Expansion: 1,18 0,32 Thermal Expansion: 1,01 0,58 Total Expansion: 2,19 0,90
Consistent Quality:
-	Uniform results when processing dental materials can not be achieved economically unless their quality is maintained from one batch to the next.
-	Each batch is checked several times during manufacture by means of in-process controls to ensure compliance with product-specific characteristics.
-	The final result of the invested material is also subject to optical and photometric test criteria using a series of reference models before a batch is finally released.
	Compressive strength test Expansion test
Physical Properties*:
Powder / Liquid Ratio 100g / 22ml   Mixing Time 1 Minute   Working Time Up to 4 Minutes   Setting Tme 8 Minutes   Setting Expansion 1.18%   Thermal Expansion 1.01%   Total Expansion 2.19%   Compressive Strength 5 MPa * At room temperature of 23°C and 100% liquid concentration